Uniden 24-148 Welder User Manual


 
GETTING STARTED
[ 11 ]
GETTING STARTED
BBaatttteerryy uussee ttiimmee ((ppeerr cchhaarrggee))
From fully charged
6 hours continuous use.
10 days when the handset is in the standby mode.
WWhheenn tthhee bbaatttteerryy cchhaarrggee bbeeccoommeess llooww
When the battery pack is very low and needs to be charged,
the phone is programmed to eliminate functions in order to
save power. If the phone is not in use, “
Low Battery
flashes and none of the keys will operate. If the phone is
in use, “
Low Battery flashes and the handset beeps.
Complete your conversation as quickly as possible and
return the handset to the base unit for charging.
CClleeaanniinngg tthhee cchhaarrggiinngg ccoonnttaaccttss
To maintain a good charge, it is important to
clean the battery contacts on the handset and
base unit with a dry cloth or a pencil eraser
about once a month.
DDoo nnoott uussee aannyy lliiqquuiiddss oorr ssoollvveennttss..
• Even when the battery
pack is not being used, it
will gradually discharge
over a long period of
time. For optimum
performance, be sure to
return the handset to the
base unit after each
telephone call.
If you must replace the
battery pack during a
telephone call, complete
the replacement of the
battery pack within
30 seconds, and you
can return to the
original call.
The last number dialed in redial memory, back up for up to 2 minutes
while you replace the battery pack.
UC772EZ ENG(24-148) 10/9/01 15:24 Page 11