Filter
Top Products
General Description
This high performance airless sprayer is a precision power tool
used for spraying many types of materials. Read and follow
this instruction manual carefully for proper operating
instructions, maintenance and safety information.
Specifications
Weight ..............................27 lbs
Capacity ...........................Up to .35 gallon (1.25 liters) per
minute
Power source ...................Electric motor, totally enclosed, fan
cooled
Power requirement...........15 amp minimum circuit on 115
VAC, 60 Hz current.
Generator .........................15 amp A/C.
Spraying pressure ............Up to 2750 PSI
Capabilities
.......................Sprays a variety of oil-based and
latex paints, primers, and stains
Pressure Control
Knob
PRIME/SPRAY
Knob
Paint Hopper Return Tube
Outlet Valve
Power Cord
4 © SprayTECH. All rights reserved.
Preparing to Paint
Attaching the Tip to the Gun
1. Lock the trigger by rotating the trigger lock forward until it
stops.
POSSIBLE INJECTION HAZARD. Do not spray without the
tip guard in place. Never trigger the gun unless the tip is
in either the spray or the unclog position. Always engage
the gun trigger lock before removing, replacing or
cleaning tip.
2. Thread the tip guard onto the gun. Tighten the nut first by
hand, then tighten more firmly with a wrench.
Checking the Outlet Valve (optional)
1.
Firmly press the optional pusher valve button on the side
of the pump housing to make sure the outlet ball valve
moves freely.
Pusher Valve Button
(optional)
Begin
tightening
the tip guard
at this angle
to achieve
the desired
spray angle
when tight.
NOTE: When attaching the tip guard to the gun, align
the tip guard as shown in the figure below,
then tighten with a wrench.
WARNING
Trigger locked
(gun will not spray)
Trigger unlocked
(gun will spray)