Wagner SprayTech 524019 Paint Sprayer User Manual


  Open as PDF
of 24
 
4 Finish 230 AC Compact
GB
Safety Regulations
1. Safety regulations for AirCoat spraying
1.1 Explanation of symbols used
This manual contains information that must be read and understood
before using the equipment. When you come to an area that has one
of the following symbols, pay particular attention and make certain to
heed the safeguard.
This symbol indicates a potential hazard that
may cause serious injury or loss of life. Important
safety information will follow.
Attention
This symbol indicates a potential hazard to you
or to the equipment. Important information that
tells how to prevent damage to the equipment or
how to avoid causes of minor injuries will follow.
Danger of skin injection
Danger of re from solvent and paint fumes
Danger of explosion from solvent, paint fumes
and incompatible materials
Danger of injury from inhalation of harmful
vapors
i
Notes give important information which should
be given special attention.
HAZARD: INJECTION INJURY
A high pressure stream produced by this equipment
can pierce the skin and underlying tissues, leading to
serious injury and possible amputation.
DO NOT TREAT AN INJECTION INJURY AS A SIMPLE
CUT! Injection can lead to amputation. See a
physician immediately.
The maximum operating range of the unit is 193 bar
(19.3 MPa, 2800 PSI) uid pressure.
PREVENTION:
• NEVERaimthegunatanypartofthebody.
• NEVERallowanypartofthebodytotouchtheuidstream.
DONOTallowbodytotouchaleakintheuidhose.
• NEVERputyourhandinfrontofthegun.Gloveswillnot
provide protection against an injection injury.
• ALWAYSlocktheguntrigger,shuttheuidpumpoand
release all pressure before servicing, cleaning the tip guard,
changing tips, or leaving unattended. Pressure will not be
releasedbyturningotheengine.ThePRIME/SPRAYvalve
or pressure bleed valve must be turned to their appropriate
positions to relieve system pressure. Refer to the PRESSURE
RELIEF PROCEDURE described in this manual.
• ALWAYSkeeptipguardinplacewhilespraying.Thetipguard
provides some protection but is mainly a warning device.
• ALWAYSremovethespraytipbeforeushingorcleaningthe
system.
• Thepainthosecandevelopleaksfromwear,kinkingand
abuse. A leak can inject material into the skin. Inspect the
hose before each use.
• NEVERuseaspraygunwithoutaworkingtriggerlockand
trigger guard in place.
• Allaccessoriesmustberatedatorabovethemaximum
operating pressure range of the sprayer. This includes spray
tips, guns, extensions, and hose.
NOTE TO PHYSICIAN:
Injection into the skin is a traumatic injury. It is important to
treat the injury as soon as possible. DO NOT delay treatment
to research toxicity. Toxicity is a concern with some coatings
injected directly into the blood stream. Consultation with
a plastic surgeon or reconstructive hand surgeon may be
advisable.
 previous next