Filter
Top Products
15
Step 11: Multi-Opener/Light Fixture Programming
Switch Settings: Light Fixture
If installing more than one opener in the same garage, the light fixtures can be programmed to only function
with a desired opener. Leaving the light fixture as is from the factory may cause all light fixtures to light when
any one of the openers are activated. The opener jumpers and light fixture switches need to be matched to allow
for the opener to activate a specific light fixture. To
adjust switch location on light fixture, slide switches
on top of light fixture housing.
NOTE: After settings are
complete, re-install the right
hand gear assembly to the
drive gear (refer back to
Step 4).
Jumper Settings: Opener
On the right side of the opener, insert jumper(s)
provided in the hardware pack to match switch settings
of the light fixture above.
-C-
SWITCH 1 (ON)
SWITCH 2 (ON)
NO JUMPERS
FOR PINS 1 & 2
PIN 1
PIN 2
PINS 1 & 2
SWITCHES
LIGHT FIXTURE
-A-
SWITCH 1 (OFF)
SWITCH 2 (OFF)
(FACTORY
SETTING)
-B-
SWITCH 1 (ON)
SWITCH 2 (OFF)
-D-
SWITCH 1 (OFF)
SWITCH 2 (ON)
-A- -B- -C- -D-
-A- -B-
-C-
-D-