Filter
Top Products
3
IMPORTANT SAFETY INSTRUCTIONS FOR
INSTALLATION AND USE
IMPORTANT SAFETY INSTRUCTIONS FOR
INSTALLATION AND USE
READ AND FOLLOW ALL
INSTALLATION INSTRUCTIONS.
Do not connect the opener power
head to a power source until
instructed to do so.
Where possible, install the opener
power head seven feet or more
above the floor. For products
requiring an emergency release,
mount emergency release six feet
above the floor.
Locate the wall station: (a) within
sight of door, (b) at a minimum
height of five feet, so small children
cannot reach it, and (c) away from all
moving parts of the door.
After installing the opener, the door
must reverse when it contacts a 1-
1/2” high object (or 2 x 4 board laid
flat) on the floor.
WARNING: INCORRECT
INSTALLATION CAN LEAD
TO SEVERE OR FATAL
INJURY. FOLLOW
INSTRUCTIONS.
WARNING: IT IS VITAL FOR
THE SAFETY OF PERSONS TO
FOLLOW ALL INSTRUCTIONS.
SAVE THESE INSTRUCTIONS
.
Install the entrapment warning label
next to the wall station in a
prominent location. For products
requiring an emergency disconnect,
install the emergency release
marking on or next to the emergency
disconnect.
Remove all ropes and remove or
make inoperative all locks
connected to the garage door before
installing the opener.
Do not wear rings, watches or loose
clothing when installing or servicing
a garage door system.
Install only on a properly installed
garage door. An improperly
balanced door could cause severe
injury. Have a qualified service
person make repairs to cables,
spring assemblies, and other
hardware before installing the
opener.
Installation and wiring must comply
with local building and electrical
codes. Connect power cord to a
properly grounded outlet. Do not
remove the ground pin from power
cord.