Filter
Top Products
Plug the female end of power cord into the inlet
connector on the back side of opener. Plug the other
end of the opener power cord into the nearest convenient
power receptacle. (If the power cord is not long enough
to reach the closest receptacle, contact a service person
for further options.) As soon as power is applied to the
opener, the light fixture will light, and the opener will
beep. If the light fixture does not light, adjust the receiver
module alignment on the light. Unplug, the power cord
then plug it back in. Repeat this process until the light
comes on. Ensure there is no obstruction between the
opener and the light fixture. Refer to Step 12: Light
Fixture Installation for the alignment procedure.
Excess power cord length must be routed and contained
safely away from any moving members.
NOTE: Do not permanently attach power cord to
building! Use only the flexible plastic clips supplied
with the opener.
WARNING TO REDUCE THE RISK OF
ELECTRICAL SHOCK, THIS EQUIPMENT HAS A
GROUNDING TYPE PLUG, THAT HAS A THIRD
(GROUNDING) PIN. THIS PLUG WILL ONLY FIT
INTO A GROUNDING TYPE OUTLET. IF THE PLUG
DOES NOT FIT INTO THE OUTLET, CONTACT A
QUALIFIED ELECTRICIAN TO INSTALL THE
PROPER OUTLET. DO NOT CHANGE THE PLUG
IN ANY WAY.
19
Step 14: Power Connection (Standard Wiring)
INLET CONNECTOR
FEMALE
END
POWER
RECEPTACLE
6’ POWER
CORD
OPENER
POWER OUTLET
RECEPTACLE
LIGHT
FIXTURE
POWER
RECEPTACLE
GROUNDING
PIN
PLASTIC
CLIP
#6 X 7/8”
PAN HEAD
SCREW