Filter
Top Products
13
Step 9: Wall Station Installation
Locate a convenient place to mount wall station. To
keep wall station out of the reach of children, measure
at least five feet up from the floor and secure wall
station base into wood wall framing using (2) phillips
head screws. Use 2 of 3 holes that best align with wood
framing. If fastening into drywall or concrete, proper
anchors (not provided) will need to be used.
CAUTION: Over tightening the screws could deform
plastic base and interfere with circuit board snaps.
NOTE: Pilot drill mounting holes using a 3/32" bit.
Insert bottom of circuit board behind bottom snap of
wall station base. Pivot circuit board up until board
snaps into place. For best results, press on circuit board
between battery terminals.
Insert battery onto circuit board being careful to match
(+) positive battery marking with (+) circuit board
marking. Align wall station cover/button assembly
with base. Press cover assembly over base until cover
snaps into place. A uniform seam between the cover
and base indicates a proper installation. Apply wall
station reference label and entrapment label in a
convenient location next to the wall station.
CIRCUIT
BOARD
BOTTOM
SNAP
PRESS HERE
BATTERY TERMINALS
COVER
ASSEMBLY
BASE
WALL STATION
REFERENCE
LABEL
ENTRAPMENT
LABEL
ALTERNATE SCREW LOCATION
(2) PHILLIPS HEAD
SCREWS
Pre-Operation Installation