Filter
Top Products
NOTE: The user must change the transmitter’s security code before using the transmitter.
This code sequence is only necessary the first time that transmitter is used.
Overview: When changing the transmitter’s security code, the user will have to hold the large button down for
approximately 10 seconds, then release the button momentarily, and finally hold the button down again for
approximately 5 seconds.
CHANGING THE TRANSMITTER’S SECURITY CODE:
1. Press and hold the large transmitter button for approximately 10 seconds until the transmitter’s LED begins
to blink rapidly. Once the LED starts blinking, release the large transmitter button; the LED will turn off.
2. Press and hold the large transmitter button again (LED will light) for approximately 5 seconds. After
approximately 5 seconds the LED will begin to blink on and off. Release the large button. The transmitter’s
LED will blink on and off three times indicating a successful security code change. The transmitter is now ready
to be programmed to the opener.
TRANSMITTER PROGRAMMING:
To program transmitter:
1. Place the emergency disconnect handle in the manual door operated position. This is for safety reasons.
2. On the front cover of the opener, press and release the red program button; the opener will beep once,
indicating activation of the program mode. The opener will remain in program mode for 30 seconds.
3. Press and hold the desired transmitter button until the opener beeps once. The transmitter is now programmed.
4. Return the emergency disconnect handle to motor operated position.
NOTE: No beeping response of the opener during the
transmitter programming indicates a programming
failure. Repeat programming 1-3.
NOTE: Programming failure can occur during the
transmitter programming if the remote control is too
close to the opener during the programming sequence.
Perform the programming with a minimum distance
of six feet between the remote control and the opener.
NOTE: The first transmitter command, after
programming, will only move the door through a six
inch up/down cycle. Normal door operation will occur
on the second use of the transmitter.
NOTE: The opener can be activated by up to six remote
control devices (including wall station, transmitter, and
keyless entry devices.) If a seventh control is
programmed, the first of the programmed controls will
be overridden and will no longer activate the opener.
CAUTION: For safety reasons, manually disconnect
using the emergency disconnect handle prior to
erasing remote controls. To clear programming of all
remote control devices, press and hold the opener’s
program button for approximately ten seconds. When the opener beeps three times, all remote controls are
erased.
25
NOTE: If there are any accessories included with your opener, install them per their instructions at this time.
HANDLE IN MANUAL DOOR
OPERATED POSITION
LARGE
BUTTON
PROGRAM BUTTON
Step 23: Transmitter Security Code Change and Programming
MOTOR IN UP POSITION
LED