Filter
Top Products
15
Burner tubes
Frame brace
Your Weber Genesis Gas Barbecue burner assembly
has been factory assembled, pressure and flame tested.
As a safety precaution we recommend you check the
burner alignment:
a) Do the valves fit into the ends of the burners? Figure
13 (a).
b) Are the ends of the burners under the washers at
the left rear and left front of the cooking box? The
screws are only guides. Do not tighten.
Figure 13 (b).
c) Are the wing nuts under the burner assembly hand
tight? Do not tighten with pliers. Figure 13 (c).
If you answered YES to a, b and c, the burners are
correctly aligned. If you answered NO, the burners are
misaligned. Contact Weber-Stephen Customer Service.
Do not use your barbecue.
Slide the cooking box to the left within the frame. Put the
washer on the bolt. Insert the bolt through the cooking
box and frame with the head of the bolt outside the box.
Figure 12. Add keps nut. Tighten by holding the bolt with
pliers while you tighten the nut with the 7/16 inch
wrench.
Figure 11
Figure 13
Figure 12
Step 11
Add cooking box
You will need: frame assembly, cooking box assembly,
1/4-20 x 2 inch bolt, nylon washer, 1/4-20 keps nut, pliers
and a 7/16 inch wrench.
Uncoil the hose.
Set the cooking box into the frame so the burner tubes
are under the frame brace. Figure 11.
(b)
Guide screw
Wing
nuts
(a)
(c)