Filter
Top Products
36
c) Connect the hose to the tank. Slide back the collar of
the quick disconnect on the tank valve. Figure 7 (a).
Push the male fitting of the regulator into the quick
disconnect, and maintain pressure. Slide the collar
closed. Figure 7 (b). If it does not engage or lock,
repeat procedure. Gas will not flow unless the quick
disconnect is properly engaged.
d) Mix soap and water.
e) Open the tank valve. Figure 8.
36
f) Check for leaks by wetting the fitting with the soap
and water solution and watching for bubbles. If
bubbles form or if a bubble grows there is a leak.
If leak does not stop, turn off the gas and contact
Weber-Stephen Customer Service. Do not use the
barbecue.
g) When leak checks are complete, turn gas supply
OFF and rinse connections with water.
LP Tank
The LP tank manufacturer is responsible for the
materials, workmanship and performance of the tank. If
the tank has a defect, malfunctions, or you have a
question regarding the tank, call the tank manufacturer's
customer service center. The phone number is on the
warning decal which is permanently attached to the
tank. If the tank manufacturer has not resolved the issue
to your satisfaction, then call Weber-Stephen Products
Co., Customer Service Center.
F
E
F
E
Figure 8
Male fitting
Regulator
Collar
Quick disconnect
engaged
Figure 7
(a)
(b)