Filter
Top Products
18
Step 17
Install bottom accessory trays
You will need: two accessory trays
Set the two accessory trays between the two frame
connectors. Figure 20.
Figure 20
Step 16
Add fuel scale
You will need: fuel scale assembly, two 1/4-20 wing nuts
and two nylon washers.
Insert indicator rod of fuel scale through the elongated
hole in the right end panel. Figure 19 (a).
Slip the bolts on the back of the fuel scale assembly
through the two small holes in the right end panel and
tank panel. Add washers, then wing nuts and tighten.
Figure 19 (b).
Figure 19
View from front left View from front right
F
E
F
E
Step 18
Install igniter
Note - The igniter wires are already attached to the Gas
Catcher Ignition Chamber and the igniter. This was
done to factory test the ignition system.
The igniter lock nut is on the igniter.
Insert the top of the igniter up through the large part of
the keyhole in the frame brace. Figure 21 (b). Loosen
the igniter lock nut and slide the igniter into the small
part of the keyhole. Figure 21 (c). Tighten the igniter
lock nut. Figure 21.
Note - If the igniter works loose, carefully tighten the
igniter lock nut with an adjustable wrench or pliers.
Figure 21
Igniter lock nut
Keyhole in
frame brace
(b) (a)
Small part of
keyhole in
frame brace
Frame brace
Frame brace
(a)
(b)
(c)