Filter
Top Products
6
A. This appliance does not have a pilot. It is equipped
with an ignition device which automatically lights
the burner. Do not try to light the burner by hand.
B. BEFORE OPERATING smell all around the appli-
ance area for gas. Be sure to smell next to the oor
because some gas is heavier than air and will settle
on the oor.
FOR YOUR SAFETY
“WHAT TO DO IF YOU SMELL GAS”
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use
any phone in your building.
• Immediately call your gas supplier from a
neighbor’s phone. Follow the gas supplier’s
instructions.
1. Set the thermostat to lowest setting.
2. Turn o all electric power to the appliance if service
is to be performed.
3. Remove control access panel.
4. Push gas control switch to “OFF.” Do not force.
5. Replace control access panel.
• If you cannot reach your gas supplier, call the
re department.
C. Use only your hand to move the gas control
switch. Never use tools. If the switch will
not move by hand, don’t try to repair it, call a
qualied service technician. Force or attempted
repair may result in a re or explosion.
D. Do not use this appliance if any part has been
under water. Immediately call a qualied service
technician to inspect the appliance and to
replace any part of the control system and any
gas control which has been under water.
CONTROL LABEL
LIGHTING INSTRUCTIONS
If you do not follow these instructions exactly, a re or explosion
may result, causing property damage, personal injury or loss of life.
WARNING
!
FOR YOUR SAFETY READ BEFORE OPERATING
TO TURN OFF GAS TO APPLIANCE
1. STOP! Read the safety information above on
this label.
2. Set the thermostat to lowest setting.
3. Turn o all electric power to the appliance.
4. HSI MODELS: This appliance is equipped with
an ignition device which automatically lights the
burner. Do not try to light the burner by hand.
5. PROVEN/INTERMITTENT PILOT MODELS:
This appliance is equipped with an ignition
device which automatically lights the pilot. Do
not try to light the burner by hand.
6. Remove control access panel.
7. Wait ve (5) minutes to clear out any gas. If you
then smell gas, STOP! Follow “B” in the safety
information above on this label. If you don’t
smell gas, go to the next step.
8. Push gas control switch to “ON.”
NOTE: Do not force.
9. Replace control access panel.
10. Turn on all electric power to the appliance.
11. Set thermostat to desired setting.
12. If the appliance will not operate, follow the
instructions “To Turn O Gas To Appliance” and
call your service technician or gas supplier.
OPERATING INSTRUCTIONS