Filter
Top Products
15
1. Loosen and remove the hex nut and flat
washer on the roller shaft with a 24mm
wrench.
2. Remove the outer roller.
3. Install a spacer on the shaft and flush
against the inner roller as shown in Figure
15.
4. Re-install the outer roller.
5. Install the flat washer and hex nut and
tighten with wrench.
6. Repeat for the other rollers if needed.
Maintenance
Before performing any
maintenance on the Stock Feeder,
disconnect it from the electrical supply by
pulling out the plug or switching off the
breaker. Also make sure the table saw is
disconnected from power.
If the power cord is worn, cut, or damaged in
any way, have it replaced immediately.
Rollers
The polyurethane rollers should be kept clean of
grease, sawdust and other debris. Use a soft
cloth with soap and water to wipe down the
rollers. DO NOT use a solvent on the rollers.
The rollers can be removed from the Stock
Feeder for replacement or maintenance
purposes. To remove a roller, loosen and
remove the hex nut and flat washer (Figure 15)
with a 24mm wrench and pull the roller(s) off the
shaft.
Drive Belt Replacement
1. Remove the guard cover (Figure 16) by
loosening and removing the three socket
head cap screws with a 5mm hex wrench.
2. Remove the old belt from around the pulley
and install the new belt.
3. Re-install the guard cover, making sure the
keyway on the shaft pulley aligns with the
key on the shaft.
Lubrication
Every 200 hours, or 30 days, insert grease into
the two grease fittings on the end of the Stock
Feeder (Figure 17), and the grease fittings on
the tip of each sprocket shaft located inside the
housing (Figure 18).
Figure 16
Figure 17
Figure 18