Filter
Top Products
17
Troubleshooting
Trouble Probable Cause Remedy
Not connected to power source. Check plug connection.
Fuse blown, or circuit breaker tripped. Replace fuse, or reset circuit breaker.
Feeder will not start.
Cord damaged. Replace cord.
Extension cord too light or too long.
Replace with adequate size and
length cord. [page 12]
Feed speed is not
sufficient; machine
has low power.
Low current from electrical supply. Contact a qualified electrician.
Workpiece jams while
feeding it beneath
rollers.
Rollers too low. Raise feeder.
Rollers too high, no traction. Lower feeder.
Workpiece slips while
passing under rollers.
Grease or debris on rollers. Clean rollers.