Xantrex Technology 50A12V Battery Charger User Manual


 
Introduction
1–2 975-0401-01-01
Standard and Protection Features
The Truecharge™ 2 Battery Charger provides the following
standard features:
•three
1
full current rated outputs
battery monitoring functions while in float mode or rest
mode
correct charging voltage for batteries when connected to
almost any single phase AC power outlet in the world
low electromagnetic interference (EMI)
automatic charge resumption, if required, after AC power
interruption
programmable custom charge settings
2
fully discharged battery charging
3
The Truecharge™ 2 Battery Charger provides the following
protection features:
battery reverse polarity protection via a replaceable
output fuse
AC input out-of-range derating and shutdown
ambient over temperature derating and shutdown
battery over-charging protection
electronic current limiting provides protection against
short circuit conditions on the charger’s output
ignition protected rating, enabling installation in engine
spaces
isolated design
1.Model TC1012 has one output and model TC1512 has two outputs. All other models
have three outputs. Each output (for models with 2 or 3 outputs) can charge different bat-
teries that either have the same chemistry or can tolerate the same charge sequence.
2.The charger can be programmed with custom charge setpoints using PC interface. This
programming can only be done using a special configuration tool operated by Xantrex or a
designated OEM.
3.The charger can initiate charging a non-damaged but zero voltage battery.