Filter
Top Products
10 11
Hammer Irons
The MILWAUKEE Breaker Hammer is ideal for chipping, chiseling, and heavy-duty break-
ing in many materials. A variety of hammer irons are available as shown.
Bull Points
This iron is ideal for general demolition work.
It moves in a random pattern and effec-
tively breaks the material from a corner or
an edge into an open area.
12" long Cat. No. 48-62-3000
18" long Cat. No. 48-62-3005
Flat Chisels
For general purpose edging, chipping, and
channeling.
12" long Cat. No. 48-62-3010
18" long Cat. No. 48-62-3015
Asphalt Cutters
For digging asphalt or hard ground (not
intended for use on concrete).
16-1/2" long Cat. No. 48-62-3090
Clay Spade
For breaking clay, hard-packed gravel, and
dirt.
5" x 5" Cat. No. 48-62-3040
Scaling Chisels
Ideal for cutting clean angles in concrete,
and for removing scale and rust. Also de-
signed to cut between drilled holes in con-
crete for large openings.
3" x 12" Cat. No. 48-62-3030
Ground Rod Drivers
Use these irons to drive ground rods.
3/4" rod Cat. No. 48-62-3070
Wood Chisels
For general purpose wood materials.
2" x 12" Cat. No. 48-62-3025
Tamper Plates
For compacting/flattening ground.
14-1/2" Cat. No. 48-62-3060
Tamper Shank
12" long Cat. No. 48-62-3065
Bushing Tools
Ideal for removing excess concrete, pro-
ducing an exterior finish, and roughing the
surface for a surface-applied substance.
Bushing Head
1-3/4" x 1-3/4" Cat. No. 48-62-3075
Bushing Shank
12" long Cat. No. 48-62-3080
1-Piece Bushing Tool
1-3/4" square Cat. No. 48-62-3085
Replacement Part
Steel Carrying Case
Cat. No. 48-55-5335
Same as supplied with the tool.
Replacement Part
Side Handle Assembly
Cat. No. 43-62-1080
Same as supplied with the tool.
Replacement Part
Dust Shield
Cat. No. 42-52-0340
Same as supplied with the tool.
ACCESSORIES
FIVE YEAR TOOL
LIMITED WARRANTY
Every MILWAUKEE tool is tested before
leaving the factory and is warranted to be
free from defects in material and work-
manship. MILWAUKEE will repair or
replace (at MILWAUKEEs discretion),
without charge, any tool (including battery
chargers) which examination proves to be
defective in material or workmanship from
five (5) years after the date of purchase.
Return the tool and a copy of the purchase
receipt or other proof of purchase to a
MILWAUKEE Factory Service/Sales
Support Branch location or MILWAUKEE
Authorized Service Station, freight prepaid
and insured. This warranty does not cover
damage from repairs made or attempted
by other than MILWAUKEE authorized
personnel, abuse, normal wear and tear,
lack of maintenance, or accidents.
Battery Packs, Flashlights, and Radios are
warranted for one (1) year from the date
of purchase.
THE REPAIR AND REPLACEMENT REMEDIES
DESCRIBED HEREIN ARE EXCLUSIVE. IN NO
EVENT SHALL MILWAUKEE BE LIABLE
FOR ANY INCIDENTAL, SPECIAL, OR
CONSEQUENTIAL DAMAGES, INCLUDING
LOSS OF PROFITS.
THIS WARRANTY IS EXCLUSIVE AND IN
LIEU OF ALL OTHER WARRANTIES, OR
CONDITIONS, WRITTEN OR ORAL,
EXPRESSED OR IMPLIED FOR
MERCHANTABLILITY OR FITNESS FOR
PARTICULAR USE OR PURPOSE.
This warranty gives you specific legal
rights. You may also have other rights that
vary from state to state and province to
province. In those states that do not allow
the exclusion of implied warranties or
limitation of incidental or consequential
damages, the above limitations or
exclusions may not apply to you. This
warranty applies to the United States,
Canada, and Mexico only.
WARNING!
To reduce the risk of injury, always unplug the tool before attaching or
removing accessories. Use only specifically recommended accessories.
Others may be hazardous.
For a complete listing of accessories refer to your MILWAUKEE Electric Tool catalog or go
on-line to www.milwaukeetool.com. To obtain a catalog, contact your local distributor or a
service center.