A SERVICE OF

logo

Saving Configuration Settings and Logging Off
Use the SAVE command to save the last configuration changes made to any of the
following parameters:
Alert
All
Community
Device
LAN_emul
Module_port
Static_route
Terminal
TFTP.
When you make changes with the SET command, they are activated immediately but
are not saved permanently. You must use the SAVE command in order to permanently
store the new parameter values. When the 6416SW is reset, only the parameter values
that have been permanently saved are loaded.
By entering the SAVE ALL command, you save the last configuration changes made to
all ATM parameters:
ONcoreATM> save all [ENTER]
5-25