7 In the ‘Gateway Name’ field, enter a name to the device. (For example: ‘gateway1.com’).
Ensure that the name you choose is the one that the Call Manager/Agent is configured
with to identify your V7111.
8 In the ‘Endpoint Name’ field, enter an intuitive endpoint name. Ensure that the endpoint
name you choose is the one that the Call Agent works with.
9 In the ‘Endpoint Numbering Offset’ field, you can enter a value to offset the numbers that
represent the gateway’s endpoints.
10 Click the Reset button and click OK in the prompt; the V7111 applies the changes and
restarts. This takes approximately 2 minutes to complete. When the V7111 has finished
restarting, the Power and Ready LEDs on the front panel are lit green.
MGCP users should continue with
Chapter 4: Changing the V7111 Username and
Password.
Configuring Basic H.323 Parameters
Accessing the Embedded Web Server
After accessing the Embedded Web Server (see
) the
H.323 ‘Quick Setup’ screen is displayed, shown in
Figure 20.
Figure 20 V7111 H.323 Quick Setup Screen
34 3Com VCX V7111 Analog Gateway Installation Guide
