21.0
Maintenance
Tank Lid
1. Disconnect the liquid treatment tubing
from the elbow tting under the HCBT inlet hopper and
place it in a secondary container.
1/2” OD Chemical Pump Port
2. Hold the HCBT Pump switch
to MANUAL and Completely empty the CBP-30 Tank.
This jog switch will reset to OFF when released.
3. Fill the CBP-30 Tank with clean water
mixed with ammonia or a mild detergent or a cleaning solution
recommended by the manufacturer of the treatment product.
Repeat step 2 to ush the entire system.
If the applicator is going to be stored in subfreezing tempera-
tures, ush with alcohol to prevent freezing which will cause
pump damage. Save all rinse water and use for next treatment
or dispose of properly by following the MSDS sheet. If a more
thorough cleaning is necessary, the metered pump kit is easily
disassembled and reassembled.
For winter storage, disconnect and drain all hoses to ensure
that no components will freeze and cause damage. Clean the
drum and seed chamber and spray with light food grade oil
to help prevent corrosion. Store the treating unit indoors to
extend the life and appearance of the unit.
NOTE: Failure to clean your treater properly, or failure to com-
pletely drain all liquid from the pump and lines after use, may
damage the equipment and void any warranties expressed or
implied. It will not damage the pump to run it dry or with the
valves in the closed position.
HCBT Pump Control Switch
HOLD
