A SERVICE OF

logo

Open as PDF
next previous
6.0
Treater Inlet End
Intstallation (continued)
3. Use a chain hoist or jack
to lift the Inlet End of the HCBT approximately 6”.
Treater Inlet End
4. Insert the Lift Rod
into the frame hole with the head of the bolt positioned up.
Adjuster Nut
5. Thread the ¾” – 10 SQ Adjuster Nut
from the bottom of the bolt up to allow approximately 4” of
space from the bottom of Adjuster Nut to the lower end of
the bolt.
4”
Lift Support
6. Position the Lift Support
below each bolt. Lower the HCBT to allow some weight to
be on the Lift Support. Position the Lift Support parallel to
the treater frame. Completely lower the HCBT onto the Lift
Support. Bolt or weld the Lift Support to the oor.