23
Base Installation
5 Adjust foot prop so that it is against the
vehicle floor.
WARNING: Never use foot prop to raise base
above vehicle seat surface. Doing so will
reduce the stability of the base.
6 Attach carrier to base.
• Verify that the green indicator band on
the release button is fully visible.
• Verify that the red line on carrier is level
with the ground.
• If angle is not correct, remove carrier and
base, then adjust recline angle as directed
on page 19.
7 Adjust carrier handle to In-Vehicle
position.
Removal
Squeeze green and red ISOFIX release
buttons on each connector (fig. D), then
pull base away from vehicle seat.
IMPORTANT: Always store ISOFIX connectors
when not in use. See page 18.
ISOFIX Guides
If necessary, use ISOFIX Guides to assist
with base attachment to ISOFIX anchors.
To use, clip ISOFIX Guide onto each
ISOFIX connector that will be used for
installation of base (Fig. E).
22
Base Installation
ISOFIX Installation
• Figure A illustrates a typical base ISOFIX
installation.
• Remove carrier before installing base.
• Verify that your vehicle is equipped with
ISOFIX anchors. If ISOFIX anchors are not
available, you must use vehicle belt
installation methods.
1 Place ISOFIX connectors in ISOFIX
Installation Mode.
• Remove ISOFIX Protective Cap and
spacers, if installed.
2 Place foot prop in Installation Mode.
•
Always use foot prop when base is
installed in vehicle!
3 Line up ISOFIX connectors on base
with anchors in vehicle (fig. B).
• If it is difficult to line up ISOFIX
connectors with ISOFIX anchors, use
Insertion Aid for assistance, as instructed
on page 23.
4 Engage ISOFIX connectors by pressing
base onto ISOFIX anchors, until a
positive click is heard (fig. C).
• Visual confirmation can be made using
the green ISOFIX indicators. Green
indicator must be fully visible from the
side when installed properly (fig. D).
• Pull base away from vehicle seat to further
verify attachment.
A
B
C
D
