5 Adjust carrier handle to In-Vehicle
position.
6 Verify that vehicle belt is tight and that
the carrier is stable.
• Base is tight when it cannot be moved
more than 1” (2.5 cm) at the belt path
• Verify that the red line on carrier is level
with the ground.
• If angle is not correct, loosen vehicle belt
and adjust recline angle.
• If there is a problem stabilizing the carrier
or achieving necessary angle, place a
tightly rolled towel in the crease of the
vehicle seat to help level the carrier.
Aircraft Installation
This child carrier is certified for use in
aircraft. Most airlines in the U.S. and
Canada will allow the use of a child
carrier if it is labeled as an approved child
carrier for airline use and fits properly on
the aircraft. Contact the airline about
their policy prior to traveling.
To install in aircraft, follow instructions
for Carrier Only Lap Belt Installation on
page 30.
• Place the carrier next to a window to
avoid blocking the aisle.
• If the aircraft belt is too short, ask the
flight attendant for a Belt Extender.
31
Carrier Only Installation
Lap Belt Installation
• Figure A illustrates a typical rear facing lap
belt installation of carrier only.
WARNING: Do not install this carrier using a
non-locking ELR vehicle belt, unless a belt
shortening clip is used. Refer to the vehicle
owner’s manual for instructions on correct
use of vehicle belts with child carriers.
1 Place the carrier rear facing on the
vehicle seat.
2 Route vehicle belt through both belt
guides (fig. B).
3 Verify that the vehicle belt is not
twisted, then buckle (fig. C).
• When correctly reclined, the red line on
carrier will be level with the ground.
• If there is a problem stabilizing the carrier,
place a rolled towel in the crease of the
vehicle seat to help level the carrier.
WARNING: Only raise carrier as described
above. Do not raise the carrier off of the
front edge of the vehicle seat; doing so will
reduce the protection for your child.
4 Push the carrier firmly into the vehicle
seat while removing slack from the
vehicle belt (fig. D).
30
Carrier Only Installation
A
B
C
D
