8 Press the base firmly into the seat while
removing slack from the vehicle belt,
(fig. E).
9 Close the lock-off over the vehicle belt
(fig. F), then slide clip in to secure.
10 Verify that vehicle belt is tight and that
the base is stable.
• Base is tight when it cannot be moved
more than 1” (2.5 cm) at the belt path.
11 Adjust foot prop so that it is against the
vehicle floor.
WARNING: Never use foot prop to raise base
above vehicle seat surface. Doing so will
reduce the stability of the base.
12 Attach carrier to base.
• Verify that the green indicator band on
the release button is fully visible.
• Verify that the red line on carrier is level
with the ground.
• If angle is not correct, remove carrier and
base, then adjust recline angle as directed
on page 19.
13 Adjust carrier handle to In-Vehicle
position.
Removal
Unbuckle vehicle belt, then open lock-off
and remove vehicle belt from belt guides
27
Base Installation
Lap Belt Installation
• Figure A illustrates a typical base lap belt
only installation.
• Remove carrier before installing base.
1 Insert Vehicle Belt Installation Spacers
and ISOFIX Protective Cap (pgs. 18-19).
2 Place foot prop in Installation Mode.
•
Always use foot prop when base is
installed in vehicle!
3 Place the base on the vehicle seat with
the anti-rebound bar against the
vehicle seat back and ISOFIX
connectors in Vehicle Belt Installation
Mode.
4 Place the ISOFIX Connectors, with
protective cap installed, in the seat
bight (where the seat back and seat
cushion meet).
5 Open lock-off by sliding clip out, then
lifting release tab (fig. B).
6 Slide vehicle belt under both belt
guides (fig. C).
7 Verify that the vehicle belt is not
twisted, then buckle (fig. D).
26
Base Installation
A
B
C
D
E
F
