Additional Information
82
Editing
Cannot record with this camcorder video input from an external video device connected using a DV cable.
- Wrong signal standard. Refer also to the instruction manual of the connected device.
List of Messages (in alphabetical order)
CANNOT TRANSFER!
- You attempted to transfer a still image that cannot be displayed with this camcorder.
CARD ERROR
- A memory card error occurred. The camcorder cannot record or display the image.
The error may be temporary. If the message disappears after 4 seconds and flashes red, turn the
camcorder off, remove the card and reinsert the card. If changes to green, you can continue recording/
playback.
CARD FULL
- Memory card is full. Erase some images ( 54) to free some space or replace the memory card.
CHANGE THE BATTERY PACK
- Battery pack is exhausted. Replace or charge the battery pack ( 19).
CHECK THE CASSETTE [AUDIO MODE]
- You attempted to dub audio ( 66) on a tape recorded with an audio mode other than [ 12bit].
CHECK THE CASSETTE [BLANK]
- You attempted to dub audio ( 66) on a tape with a blank section.
CHECK THE CASSETTE [INCORRECT TAPE SPECIFICATION]
- You attempted to dub audio ( 66) on a tape recorded in HD (high definition) standard.
CHECK THE CASSETTE [REC MODE]
- You attempted to dub audio ( 66) on a tape recorded in a recording mode other than SP.
CHECK THE INPUT
- The DV cable is not correctly connected to the DV terminal ( 62), or the connected digital device is turned
off.
- The video input signal is in a different television system (PAL or SECAM).
CONDENSATION HAS BEEN DETECTED
- Condensation has been detected in the camcorder ( 89).
CONDENSATION HAS BEEN DETECTED REMOVE THE CASSETTE
- Condensation has been detected in the camcorder ( 89). Remove the cassette.
COPYRIGHT PROTECTED DUBBING RESTRICTED
- You attempted to dub a copyright protected tape ( 65).
COPY
