If a setting is incorrect, or if you want to see more details
about your hard disk configuration, go to step 2.
2.
Press
Enter. You
see a menu such as the following:
The submenu lists the settings you can change for each drive:
the number of cylinders, the number of read/write heads, the
number of sectors, the precompensation cylinder, and the
landing zone (the cylinder on which you park the heads
when moving the computer). It also displays the total storage
capacity in megabytes.
3.
If you want to change the settings for drive 1 (which is
drive C on most computers), press Enter to highlight
Drive 1:.
If you want to change the settings for drive 2,
press Enter and then to highlight Drive
2:.
4.
Press
Enter
again. You see this submenu:
Running the Setup Program
2-21
