Exec/Power Mode
The Executive and Power Mode page allows configuration of device control and power
settings.
Figure 36. Exec/Power Mode Page
Control Options Panel
• IR receiver: — The front panel IR receiver or rear panel IR receiver input can be
enabled or both can be disabled. Select from the following options:
• Disable all IR reception — When selected, ignores all IR commands.
• Enable the front panel IR receiver — When selected ignores IR commands
from the rear panel wired IR input.
• Enable the rear panel IR receiver — When selected, ignores IR commands
from the front panel IR receiver.
• Disable Video Confidence Display — Click this box to disable the video confidence
display on the player controls panel. Click again to enable the display.
Power Mode Panel
The SMD101 features an energy conserving mode. Low power standby stops the stream
and places all processing in a low power condition awaiting external commands.
• Full Power: — Click to select normal operation (default).
• Low Power‑Standby State: — Click to immediately enter standby mode. Normal
operation can be resumed by clicking the full power button, by sending a power on/off
command from the IR remote (if enabled in control options), or when a SIS command
that sets a value is received on the network or serial ports (see Automation on
page32).
• Auto Standby Delay: — Enter a time in minutes or use the list buttons to scroll to the
desired time selection the device waits after the inactivity period is met before entering
standby mode. Default: off.
NOTE: When the SMD101 comes out of standby mode, the first clip can fail to
load or play automatically. Any "set" command causes the SMD101 to resume
full power state, but command execution could be delayed. For best results,
before sending any other commands, always send a 0psav SIS command
to bring the SMD101 out of standby (see Power Save and Standby on
page68).
SMD101 • Web-based User Interface 39
