Control panel message Description Recommended action
No dial tone The product could not detect a dial tone. Check for a dial tone on the phone line by
pressing the Send Fax
button.
Unplug the telephone cord from both the
product and the wall and replug the cord.
Make sure that you are using the telephone
cord that came with the product.
Unplug the product telephone cord from the
wall, plug in a telephone, and try making a
voice call.
Make sure that the phone cord from the wall
telephone jack is plugged into the line
port.
Plug the product phone cord into a jack for
another phone line.
If the error persists, contact HP. See
www.hp.com/support/ljm1210series or the
support flyer that came in the product box.
No document sent The product did not scan any pages, or it did
not receive any pages from the computer to
transmit a fax.
Try sending the fax again.
No fax answer.
Canceled send
Attempts to redial a fax number failed, or the
Redial-no answer option was turned off.
Call the recipient to ensure that the fax
machine is on and ready.
Check that you are dialing the correct fax
number.
Check that the redial option is enabled.
Unplug the telephone cord from both the
product and the wall and replug the cord.
Unplug the product telephone cord from the
wall, plug in a telephone, and try making a
voice call.
Make sure that the phone cord from the wall
telephone jack is plugged into the line
port.
Plug the product phone cord into a jack for
another phone line.
If the error persists, contact HP. See
www.hp.com/support/ljm1210series or the
support flyer that came in the product box.
130 Chapter 10 Fax (M1210 Series only) ENWW
