IGP/PGL Emulation
97
IGP/PGL Emulation
The IGP/PGL emulation can be configured either through the printer’s front
panel or from the host computer with control codes. For a detailed description
of configuration with control codes, see the
PGL Programmer’s Reference
Manual.
For information on configuring the emulation through the printer’s
front panel, see the submenu below and the parameter descriptions that
follow.
Define CR Code (Carriage Return)
This parameter forces the printer to insert an automatic Line Feed code into
the data stream whenever a Carriage Return code occurs. This is to be used
only if the host computer does not send Line Feeds to the printer.
• CR = CR. Does not perform a line feed. The next print position will be
print position 1 of the current line.
• CR = CR + LF. Performs an automatic line feed. The next print position
will be print position 1 of the next line.
EMULATION
(from page 74)
Define CR
Code
Define LF
Code
Autowrap
Select SFCC
PI Slew
Range
CR Edit
Select Font
Select LPI
Auto
Uppercase
Skip Cmd
Prefix
Power on
IGP/PGL
CR = CR*
CR = CR + LF
LF = LF*
LF = CR + LF
Disable*
Enable
126*
(1-255)
16*
15
Disable*
Enable
0*
(1-31)
6.0*
8.0
9.0
10.0
Disable*
Enable
Enable*
Disable
Enable*
Disable
* = Factory Default
Ext Execute
Copy
UPC
Descenders
Ignore Char
IGP100
Compatbl.
Optimized
Ratio
Disable*
Enable
Enable*
Disable
Ignore Mode
Disable*
Enable
Select Char
0*
(0-255)
Disable*
Enable
Disable*
Enable
Compressed
CPI
Disable*
Enable
IGP/PGL &
LP+
Error Report
On*
Debug Mode
Fault
Off
