142
Other Settings for the Remote Controller
—Continued
This section explains how to change the remote control-
ler’s ID. You may need to change this if the RDC-7.1’s
remote controller interferes with other IntegraRESEARCH/
Onkyo components located in the same room.
Note:
If you change the remote controller’s ID, be sure to select
the same ID on the RDC-7.1. For details on setting up the
RDC-7.1’s remote control ID, refer to the “Remote Con-
trol Setup Sub-menu” section on page 91. The default ID
for both the RDC
-
7.1 and remote controller is 1.
Changing the Remote Controller’s
Control ID
1
Hold down the remote controller’s [Cus-
tom] button for more than three seconds.
The remote controller enters Custom mode.
2
Roll the scroll wheel to select “SETUP”
menu, and then press the scroll wheel.
3
Roll the scroll wheel to select ID menu,
and then press the scroll wheel.
4
Roll the scroll wheel to select an
ID—1 (default), 2, or 3—and then
press the scroll wheel.
Select the same ID as that set on the
RDC-7.1.
