ELECTRICAL SYSTEM 13-15
Ignition System
Ignition Coil Primary Peak Voltage Check
•
Remove:
Shrouds
Side Covers
Seat
Fuel Tank
•
Disconnect the spark plug cap from the spark plug [A].
•
Connect the new spark plug [B] to the spark plug cap,
then ground it to the engine.
NOTE
○
Measure the voltage with each lead connected c or-
rectly. The correct value may not be obtained if
disconnected.
○
Maintain the correct value of compression pressure for
the cylinder. (Be sure to measure the voltage with the
spark plug installed to the cylinder head.)
•
Connect the peak voltage adapter [A] between the termi-
nal of primary lead (orange) and ground connection of the
lead of the ignition coil [B].
Special Tool - Peak Voltage Adapter: 57001-1415
Type: KEK-54-9-B
Hand Tester: 57001-1394
Connection:
Tester Positive → Ground Lead [C]
Tester Negative →Orange Lead [D]
•
Shift the gear to the neutral position, then push the engine
stop button.
•
Crank the engine by kicking the pedal several times to
measure the peak voltage of the primary ignition coil.
Peak Voltage:
DC 115 V or above
WARNING
Do not touch the metal portion of the probe in case
of measuring the voltage, or you may receive a se-
rious electric shock.
If the voltage is less than the specified value, see the next
page.
