5-14 ENGINE RIGHT SIDE
Primary Gear
Primary Gear Removal
•
Remove the right engine cover (see Right Engine Cover
Removal)
•
Remove the circlip [A], and take off the primary gear [B]
and water pump drive gear .
Special Tools - Outside Circlip Pliers: 57001-144
Primary Gear I nstallation
•
Put the water pump drive gear [A] and primary gear [B] on
the crankshaft [C]. For the both gears, installation either
obverse or reverse side is available.
Primary Ge ar Removal (KX65A6F
∼
)
•
Remove the right engine cover (see Right Engine Cover
Removal).
•
Remove the magneto cover.
•
Remove the p rimary gear nut [A], washer, and the primary
gear [B].
○
Primary gear nut is left-hand threads.
NOTE
○
Use the fly wheel & pulley holder to prevent the crank-
shaft from the rotating.
Special Tools - Flywheel & Pulley Holder: 57001-1605
Primary Gear Installation (KX65A6F
∼
)
•
Insert the primary gear [A] to the crankshaft then hollow
side facing to the outside.
•
Install:
Spring Washer [B]
Primary Gear Nut [C]
