IP Routing Commands
4-249
4
router rip
This command enables Routing Information Protocol (RIP) routing for all IP
interfaces on the router. Use the no form to disable it.
Syntax
[no] router rip
Command Mode
Global Configuration
Default Setting
Disabled
Command Usage
• RIP is used to specify how routers exchange routing table information.
• This command is also used to enter router configuration mode.
Example
Related Commands
network (4-250)
timers basic
This command configures the RIP update timer, timeout timer, and garbage-
collection timer. Use the no form to restore the defaults.
Syntax
timers basic update-seconds
no timers basic
update-seconds – Sets the update timer to the specified value, sets the
timeout time value to 6 times the update time, and sets the garbage-
collection timer to 4 times the update time.
(Range for update timer: 15-60 seconds)
Command Mode
Router Configuration
ip rip authentication key Enables authentication for RIP2 packets and specifies keys IC 4-255
ip rip authentication mode Specifies the type of authentication used for RIP2 packets IC 4-256
show rip globals Displays global configuration settings and statistics for RIP PE 4-257
show ip rip Displays RIP configuration information for each network interface PE 4-257
Console(config)#router rip
Console(config-router)#
Table 4-82 Routing Information Protocol Commands
Command Function Mode Page
