WAN and System Configuration 2-23
IP Setup
These screens allow you to configure your network’s use of the IP networking protocol.
• Details are given in “
IP Setup” on page 6-2.
Filter Sets
These screens allow you to configure security on your network by means of filter sets and a basic firewall.
• Details are given in “
Security” on page 9-1.
IP Address Serving
These screens allow you to configure IP address serving on your network by means of DHCP, WANIP, and BootP.
• Details are given in “IP Address Serving” on page 6-17.
Network Address Translation (NAT)
These screens allow you to configure the Multiple Network Address Translation (MultiNAT) features.
• Details are given in “Multiple Network Address Translation” on page 3-1.
Stateful Inspection
Stateful inspection is a security feature that prevents unsolicited inbound access when NAT is disabled. You
can configure UDP and TCP “no-activity” periods that will also apply to NAT time-outs if stateful inspection is
enabled on the interface. Stateful Inspection parameters are active on a WAN interface only if enabled on your
Gateway. Stateful inspection can be enabled on a profile whether NAT is enabled or not.
Stateful Inspection
UDP no-activity timeout (sec): 180
TCP no-activity timeout (sec): 14400
Add Exposed Address List...
Exposed Address Associations...
Return/Enter goes to new screen.
Return/Enter to configure Xposed IP addresses.
