Control Function between the Unit and External Component
52
Control Function between the Unit
and External Component
You can enable the control functions between the unit
and external devices using the terminals below. Special
devices or cable connections are necessary to enable the
functions. For more information about preparation, contact
the specialized stores.
RS232 port
Use the port for connection with a commercially available
integrated control system that can enable home
automation. Some integrated control systems provide a
centralized operation with a single touch panel controller
in order to control audio and video home appliances
and security devices together. For more information
about adopting an integrated control system, contact the
specialized stores.
IR jack
If you use a multiroom remote control kit such as Xantech
and Niles with this jack, you can operate the unit with the
remote controller even when you are in a separate room, or
operate the unit with the remote controller even if its remote
control sensor is difficult to see. For more information
about adopting a multiroom remote control kit, contact the
specialized stores.
Signal flow
Main room Zone
Remote controller
Connecting
block
IR
receiver
12V trigger output jack
You can enable power link operation when you connect
the unit and an external device such as power amplifier
equipped with 12V trigger input jack. When the Zone 2
function of the unit is turned on, the power link operation
will be activated with a control signal of maximum
12V/150mA output from the 12V trigger output jack. For
connection, use a monaural mini plug cable.
