A SERVICE OF

logo

General Installation
Installation Manual 119
7. Close the latches on both systems.
8. Open the ROM Cover in the Slave System and set the Master / Slave Switch on the CPU
Card to "Slave" position.
9. Turn the power on.
Note
System Connection is completed about three minutes after the power is turned on. To
confirm System Connection completion, try to call a Slave System extension from a Master
System extension.
To turn the power on for the first time, refer to Section 2.6 "Starting the System for the First
Time".
The master and slave must have the same version software. Otherwise, System Connection
will not work properly.
When you install an ISDN Line Unit, you should install it to the Master System first and
then the Slave System. If only installed to the Slave System, noise may occur.
Connection Cable
REMOTE
DISA
MASTER SLAVE