28
XH VALUE - Fax on Hour of Day This option sets the time of day to transmit fax reports. It
works in conjunction with XW and XM, above. The RayTemp will attempt to fax the specified data
on the specified day (above) and at this specified time. Military time is used with values of 0 to
23, 12 is noon. If the first attempt is not successful then the RayTemp will make two more
attempts at 10 minute intervals. Where multiple RayTemps are calling into one fax machine it's
very important to set each control to a different day and/or time, otherwise some controls may
always get a busy line.
MC MODEM TEST This screen provides for modem testing and manual fax transmission of
reports and graphics. The following table describes the options in this window. These options are
selected using the FIELD keys and activated by pressing the PLUS key. The "Status:" line in this
window reports progress of the action as shown in the second table below.
Option Transmit Function Pages
Setup "Modem Setup" command to modem N/A
Disconnect "Modem Disconnect" command to modem N/A
Pager Alarm "Pager Dial-Out" command to modem N/A
Fax Alarm Warning message, identifies location 1
Fax Report Installation report 2
Fax Year Trend graphs for last 12 months 3
Fax Month Trend graph for the 4 month period 1
Fax Week Detailed graphs for the last 7 days 4
Fax Today Detailed graph for one day, today 1
Fax Yesterday Detailed graph for one day, yesterday 1
Fax All Report and all graphs 7
Status Description
(blank) No Activity
Sending Transmission in process. This message may remain for up to 12
minutes depending on the action selected
OK Data modem or fax modem has successfully completed the
operation. Failed data modem or fax modem did not reply or was
unable to complete the action requested
Failed Data modem or fax modem did not reply or was unable to complete
the action required
Note: The "Pager Alarm" action will always reply "Failed" because the modem does not connect
with another modem. In this screen, no actions will retry in the event of transmission failure (press
plus (+) again). However when actual alarm conditions occur or when reports are scheduled for
automatic transmission the RayTemp will retry. Up to three attempts will be made, per day, at 10-
minute intervals.
