Connect the dispenser door tube ( 5
) and then insert a clip on the coupler
with pulling tube.
Connect the connector ( 4 ) on the left
side door and one connector ( 3 ) on
the right side door.
The clip is enveloped inside of the
top cap.
The dispenser door tube ( 5 ) must be fully inserted to the marked line to
prevent water leakage from the dispenser.
Position the top table ( 2 ) in place. Insert and tighten
the 3 screws into the top table with a philips screw
driver(+). After door opened, reinsert the cap top table
( 1 ) and close the doors.
When reattaching the top table, make sure that the
wires are not pressed or damaged by the hinge
cover.
After assembling, close the door and check to see
whether the door has gaps between gaskets or is
tilted.
If you see one of them, please refer to “Adjusting
the doors” on page 18.
4
3
5
dispenser door tube
coupler
CAUTION
1
2
