Operating your French Door Refrigerator
REMOVING THE FREEZER ACCESSORIES
To remove - Pull both bracket the tilting pocket ( 1 ) by pulling both
suport guards ( 2 ) aside. And take out both support
guards by pulling them aside.
To replace - Hook the ends of the pocket into both brackets ( 2 ) and
push down until it locks into place.
To remove - Pull the drawer out to full extension.
Tilt up the rear of the drawer and lift straight out.
To relocate - Place the drawer onto the rails( 4 ) by tilting it up.
Lower the drawer into place until it is horizontal and
slide the Drawer( 3 ) in.
To remove the drawer - Pull the drawer out fully. Tilt up the rear
of the bin and lift it out to remove.
To relocate the drawer - Place the bin into the rail assembly.
To remove the divider - Pull the divider straight up.
To relocate the divider - Hook the top corners of divider( 1 )
over the hole of the bin( 2 ).
Do not allow baby or children go inside the drawer bin.
They could damage the refrigerator and seriously injure
themselves. Do not sit on the freezer door. The door may
break. Do not allow children to climb into the freezer basket.
If you remove the divider to clean the basket bin, you must
reinstall the divider using 2 screws after cleaning to prevent
children from getting trapped inside the basket.
2
1
3
4
1
2
CAUTION
WARNING
