Setting up your French Door Refrigerator
ADJUSTING THE LEVEL
After putting the doors back on the refrigerator, make sure the refrigerator is level so that you can make final
adjustments.
If the refrigerator is not level, it will not be possible to get the doors perfectly even, which may cause moisture
condensation and increased energy bills.
For example, when the left side of refrigerator is lower than the right side, make sure to do the following steps.
Disassemble the freezer drawer. (Refer to 11 page)
Remove the two screws( 1 ) attached to the cover leg front ( 2 ) with a Philips screwdriver(+).
Remove the cover leg front ( 2 ) by lifting the bottom part of the cover leg front up and pulling it out.
Insert a flat-blade screwdriver(-) into a notch on the left control lever, and turn it count clockwise to level
the refrigerator. Turning it clockwise to lower the refrigerator and counterclockwise to raise it.
Both control levers must be surely touching the floor to avoid possible personal injury or property
damage because of tipping.
For the left side is higher, do it with right lever.
It is difficult to remove the cover leg front from the refrigerator so we do not recommend making small
adjustments wIth the control lever. Instead refer to the next page for the best way to make minor
adjustments to the doors.
CAUTION
flat-blade screwdriver(-)
flat-blade screwdriver(-)
Control Lever
Control Lever
2
1
