2. Press [A] to select the add/cancel devices
option.
3. Press [C] to remove an existing device.
4. The display will prompt you to enter the device
number (01 - 30). Enter the device number
and press [ENT]. The control panel will give a
rising multi-tone sound.
5. If required, repeat from step 3 for other devices
or press [ESC] to leave this programming
option.
Re-Map Keypad Circuits
This option allows the engineer to re-map the
remote keypad circuits. By default all wirefree
devices are allocated to circuits 01 - 30 and
remote keypad circuits are allocated to circuits 31
- 38. Using this option it is possible to re-map the
remote keypad circuits to circuits 01 - 30. For
example if your system of only uses 10 wirefree
detectors and one remote keypad, you can
re-map circuits 31 and 32 (remote keypad 1) to
circuits 11 and 12 so that the circuit numbering
remains sequential.
☞
Wirefree detectors cannot be mapped to
circuits 31 to 38. To re-map a wirefree
detector it must be cancelled from the
system and then relearnt to a new device
number.
34
Engineer’s Menu 1 TS690R Installation Manual
Enter device No (31 - 38)
e.g. 31
The display shows the
current mapping.
Enter new circuit No.
e.g. 11
C
E / MENU 1
MAP? --
MAP? 31
TO 11
Re-Map Keypad Circuits Flowchart
Enter the device
number 01 - 30.
A
= Cancel devices
C
E / MENU 1
AD D / CANX
DEV ? --
Cancel Devices Flowchart
