VISORNET – Appendix
II-34
Doc. DM245-I
Rev. 7.0
Press any key to change the baud rate
..........
Set baud rate to 115200 and send the file with Xmodem
with chk protocol.
When the transfer finish, reset baud rate to 9600.
Example of the change in the transfer speed
Figure 2.1: Loading code by XModem through Hyperterminal
II - 1.3. Updating in master-slave environments
For master-slave environments, you must teleload the master device through one of
the previously described procedures. Once the master device has been teleloaded you
can proceed as described below:
When a master device has slave devices, a new button entitled UPLOAD appears on
the lower button bar. You can perform BIOS software and slave devices’ application
updating to the version possessed by the master device.
The configuration parameters described in the following paragraphs are the specific to
each device. To access these parameter configuration forms, you need to previously
select the device you wish by clicking on the icon representing the said device.
