3Com 3012 (3C13612) Saw User Manual


 
Preparing to Install the Router 21
The equipment room is dust-proof
Adequate temperature and humidity conditions prevail
The operator wears the ESD-preventive wrist strap, ESD-preventive gloves and
ESD-preventive clothes while handling the circuit board.
The dismantled circuit board is placed upward on the ESD preventive
workbench, or put into an ESD preventive bag.
You avoid direct contact with the elements of the circuit board.
Electromagnetic Discharge
To prevent damage by electromagnetic discharge, do the following:
Take effective measures against electrical net interference for the power supply
system.
Separate the working ground of the router from the grounding device of the
power equipment, or thunder proof grounding.
Keep the router away from wireless launchers, radar launchers and other high
frequency and high current equipment.
Lightning Damage
To minimize the risk of lightning damage do the following:
Install a lightning arrester on the input end of a telephone cable, ISDN line or
T1/E1 line.
Ensure that the PGND wire of the chassis is well grounded
Ensure that the neutral point of the socket of AC power supply is well
grounded
Install a lightning arrester at the input end of the power supply
Workbench
Requirements
Whether you install the router in a rack or place it directly on the workbench, it is
necessary to ensure that:
Airflow is not restricted around the router.
The cabinet and workbench are strong enough to support the weight of the
router and other installation accessories.
The cabinet and workbench are well grounded.
Installation Checklist After you verify that the installation conditions comply with these requirements,
open the packing case of the router and check the contents against the your order
contract. Contact your Service representative if you find any discrepancies.
To install your router, you will need:
Tools
Phillips screwdriver
Flat-head screwdriver
ESD-preventive wrist strap and ESD-preventive gloves
Flat-blade screws (used in wall mounting)
Cables