3M 05 de 3M Paint Sprayer User Manual


  Open as PDF
of 22
 
9
3
10
Do not immerse the spray gun in solvent.
Do not point the spray gun up while
cleaning it.
Spray Gun Care and Cleaning
Do not wipe the spray gun with a cloth
soakedinsolvent;ringouttheexcess.
Note: Your spray gun may be made
from aluminum and may contain
aluminum components. Certain
solvents containing Methylene
Chloride and Tricloromethane are
not chemically compatible with
aluminum.
Read, understand and follow all
safety statements as well as wear
appropriate, approved personal
protective equipment per the
applicable MSDS and material
container labels for cleaning
solutions.
You must lubricate the moving
components after every cleaning the
spray gun. Cleaning washes away the
lubricants that protect the friction points.
Use an appropriate lubricant such as
petroleum jelly.
Do not use metal tools to clean the air
cap holes as this may scratch them;
scratches can distort the spray pattern.
Relievethepressurefromthespray
gun and cup before servicing.
1 Turn off the air supply to the
spray gun.
2. Disconnect air line from the
spray gun.
3. When using a 3M™ PPS™ cup,
pull the trigger and invert spray gun
(fullyopen,notpartially)toreturn
unused material to spray gun cup.
General System Maintenance
Lubricate
Lubricate
Pivot Post Cavity
Fan Adjustment Knob
Fig. 2
Adjusting the Fan Pattern Size
The fan size is regulated by using the
fan adjustment knob as noted in Fig. 2.
As a starting point, gently turn the
knob clockwise until you feel no
furtheradjustment.Next,turntheknob
counter-clockwise one full rotation. The
fan adjustment will allow you to spray
from a small round to a full fan pattern.
The pattern can also be changed from
vertical to horizontal by rotating the air
cap a ¼ turn.
General Set Up and Spray Gun Use cont.
WRONG
Right
90º
6” - 8”
Spray Technique
1. To achieve the best results when
spraying material, keep the spray
gun perpendicular to the surface
and maintain a consistent distance
ofapproximately(Series05-100)6
to8inches(160-200mm),(Series
05-300)4to6inches(100-160mm)
from the object being sprayed.
2. Use smooth, even strokes across the
surface to be sprayed with 50%
over-lap.
3. Paint using parallel strokes. This
technique applies all coatings evenly
without cross coating.
Note: The small round pattern can
be achieved by closing down the fan
adjustment, triggering the spray gun
lightly, and maintaining a distance from
yourtargetof2to4inches(50-100mm).
RIGHT
Horizontal Pattern
Vertical Pattern
 previous next