3M 05 de 3M Paint Sprayer User Manual


  Open as PDF
of 22
 
11
3
12
11.Installtheuidnozzlewiththe
wrench.Tightentheuidnozzle
securely to obtain a good seal. Install
and tighten air cap.
12. Installtheuidneedlefromthe
rear of the spray gun. Insert needle
adjustment screw and then thread
the needle adjustment screw to the
desired depth.
Spray Gun Care and Cleaning cont.
10. Scrub the retaining ring, air cap and
uidnozzlewithasoft-bristlebrush.
To clean out air cap holes, use a
small brush. Clean the air cap and
uidnozzleaftereachuse.Donot
soak the retaining ring in solvent for
prolonged periods of time.
13. Dampen a soft cloth with solvent and
wring-outtheexcess.Pointthespray
gun down and wipe off the outside of
the spray gun.
9. With the spray gun pointed down,
clean the front of the spray gun,
using a soft-bristle brush and
solvent.
Cleantheairlineltersdaily.
Checkforanyuidleakagefromthe
spray gun and gravity cup.
Flush the spray gun before changing
colors and when done operating the
spray gun.
ATTENTION
Solvent left in the spray gun air
passages could result in a poor quality
paintnish.Donotuseanycleaning
method which may allow solvent into the
spraygunairpassages.Donotexpose
air regulators and gauges to solvent as
damage may occur.
Cleaning Process
1. Relievethepressure.
2. Refertoyourcuporuidsource
manual for removal and cleaning.
3. To retain unused material or
temporarilystoremixedmaterial
see your Local, State, Federal and
OSHA guideline, along with material
manufacturer’s recommendations for
storage.
4. Flushthespraygun.(Toush,run
water or compatible and compliant
solventintothespraygunuid
passage while triggering the
spraygun).
5. Removetheaircap.
Spray Gun Care and Cleaning cont.
8. Dip the end of a soft-bristle brush into a
compatible solvent. Do not continuously
soak the brush’s bristles with solvent
and do not use a wire brush.
Wrench for 05-100
spray gun
Wrench for 05-300
spray gun
Fan
Adjustment
Assembly
Fluid
Nozzle
Packing
Nut
Gravity
Cup
Fan
Adjustment
Packing
Nut
& Fluid
Nozzle
Valve
Stem
Gravity
Cup
6. Unscrew the needle adjustment screw
attherearofthespraygun.Remove
the needle adjustment spring. The
needle should then be able to be
removed from the rear of the spray gun.
7. Removetheuidnozzlewiththe
wrench.
 previous next