Agilent Technologies 5749A Welding System User Manual


 
Service Appendix C
Series N5700 User’s Guide 119
Command Errors (these errors set Standard Event Status register bit #5)
100 Command error
Generic syntax error.
101 Invalid character
An invalid character was found in the command string.
102 Syntax error
Invalid syntax was found in the command string. Check for blank spaces.
103 Invalid separator
An invalid separator was found in the command string. Check for proper use of , ; :
104 Data type error
A different data type than the one allowed was found in the command string.
105 GET not allowed
A group execute trigger is not allowed in a command string.
108 Parameter not allowed
More parameters were received than were expected.
109 Missing parameter
Fewer parameters were received than were expected.
110 Command header error
An error was detected in the header.
111 Header separator error
A character that was not a valid header separator was found in the command string.
112 Program mnemonic too long
The header contains more than 12 characters.
113 Undefined header
A command was received that was not valid for this instrument.
114 Header suffix out of range
The value of the numeric suffix is not valid.
120 Numeric data error
Generic numeric data error.
121 Invalid character in number
An invalid character for the data type was found in the command string.
123 Exponent too large
The magnitude of the exponent was larger than 32000.
124 Too many digits
The mantissa of a numeric parameter contained more than 255 digits, excluding leading zeros.
128 Numeric data not allowed
A numeric parameter was received but a character string was expected.
130 Suffix error
Generic suffix error
131 Invalid suffix
A suffix was incorrectly specified for a numeric parameter.
134 Suffix too long
The suffix contains more than 12 characters.
138 Suffix not allowed
A suffix is not supported for this command.
140 Character data error
Generic character data error