Filter
Top Products
LIBRA-04 M MANUAL COPY ROUTER
11 / 19
IV.2 – THE REQUIRED OPERATION ZONE
ATech recommends a minimum of 100 cm (40”) clearance on the front, a minimum of 30
cm (12”) clearance at the back side of the entire assembly and a minimum of 150 cm
(59”) clearance on the sides.
The following figure shows the recommended minimum safe operation area.
Figure 4-2 The settlement of machine
IV.3 – INSTALLATION and ASSEMBLY OF
MACHINE
Ensure that the ground is even and level. Ensure that there is sufficient space
around the machine for easy maneuvering, safe operation and servicing / maintenance
access.
The electric connection of the machine has to be carried out by a qualified
electrician. Routing panel should be of high quality. A good grounding system is very
important because it will prevent possible electrical injury.
Voltage fluctuation, low and high voltage are very dangerous for the machine. Use
voltage regulator to prevent these problems. Otherwise, ATech is not responsible for
possible defects.