Specications 7
ULTRAPAR UP1200
Cleaning the reector5.
Disconnect the spotlight from the mains and remove the lamp casing as described in chapter =
2.1.
Remove the color frame = [11] (chapter 4), the protective mesh and lens [10] (chapter 3.1), so that
the reector is easily accessible.
Cleaning the reector: Use oil-free compressed air or a soft, lint-free cotton cloth. Tenacious =
stains can be removed by adding some mild soap water, however, don’t forget to remove all
soap water remnants as well!
Remount the spotlight (see chapters 2.1 and 3.2). =
Never clean the reector with commercial window cleaners, as the chemical substances +
contained in these agents can damage the reector insert!
Don’t use paper towels or other material with a rough surface to wipe the reector clean, +
so as to avoid scratches damaging the reector surface.
Avoid touching the reector with bare hands. Oily nger marks can bake onto the glass +
surface and substantially lower optical quality.
Suspended installation6.
Use the mounting bracket {1} to attach your spotlight to a stand or truss. Always use M12 steel
screws to fasten the spotlight. Your UP1200 must be secured with an additional safety steel cable
(not included). Use the steel cable xed to the spotlight casing (eyelet [15]).
Once the spotlight has been adjusted, it must be secured in place with the locking screw [14].
Specications7.
Power 575 W max. (120 V / 240 V)
Max. room temperature Ta = 45°C
Max. temperature of exterior surfaces Tmax = 175°C
Dimensions (Height x Diameter) approx. 11 3/4" (300 mm) x 9 1/4" (237 mm)
Weight approx. 8.38 lbs (3.8 kg)
BEHRINGER is constantly striving to maintain the highest professional standards. As a result of these efforts, modications may be made
from time to time to existing products without further notice. Specications and appearance may differ from those listed or shown.