Black Box VX-HDMI-POE-VTX Router User Manual


 
724-746-5500 | blackbox.com Page 19
Chapter 2: Overview
Table 2-3. Function buttons (continued).
Button Action Description
F1
1. Press and hold the F1 button.
2. Apply power to the unit.
3. Release right after the
Network Status LED starts
blinking.
4. Power cycle the unit.
Resets the box to factory
defaults.
2.6.5 EDID Copy
Copying the EDID will enable the receiver to send correct resolutions to your output.
Although the default EDID will work in most cases, some monitors will not work
with it.
NOTE: EDID copy is required for DVI monitors.
To copy the EDID:
1. To copy EDID from a specific receiver to a specific transmitter, both receiver and
transmitter must be configured to the same channel.
2. Hold down the function button on the receiver and plug in the power.
3. Continue to hold down the function button until the network LED starts blinking.
EDID is now copied to the receiver.