Filter
Top Products
9
1. Fasten the lamp bracket (A) Fig. 13, to the top
cover of the machine, using two M6x1x12mm cap head
screws (B) and 1/4 in. lockwashers as shown.
2. Peel backing from cord clamps (C) Fig. 13A, and
apply one clamp at each of the locations shown. Make
certain the lamp cord is routed out of the way of the
blade, then secure cord (D) to cord clamps (C) as
shown in Fig. 13A.
3. The flexible lamp operates independently of the
band saw. To turn the lamp on and off, rotate switch (E)
Fig. 13A.
WARNING: FIRE HAZARD: To reduce the risk of
fire, use 40 watt or less, 120 volt, reflector track type
light bulb (not supplied). A standard household light bulb
should not be used. The reflector track type light bulb
should not extend below the lamp shade.
ATTACHING LAMP TO
MACHINE
FASTENING BAND SAW
TO SUPPORTING SURFACE
WARNING: The machine must be secured to a
supporting surface. Four holes are provided in the band
saw base for this purpose, three of which are shown at
(A) Fig. 14.
Fig. 13A
E
F
C
C
D
Fig. 14
A
A
Fig. 13
A
B