Filter
Top Products
TO REMOVE BATTERY PACK: Depress
the battery release button as shown in figure
D and pull battery pack out of the tool.
OPERATING INSTRUCTIONS
WARNING: Always use proper eye
protection that conforms to ANSI
Z87.1(CAN/CSA Z94.3) while operating
this power tool.
NOTE: Before cutting any type of
material, be sure it is firmly anchored or
clamped to prevent slipping.
to be cut.
maximum speed before starting the cut.
while cutting as shown in figure D.
Whenever possible, the saw shoe must
be held firmly against the material being
cut. This will prevent the saw from
jumping or vibrating and will minimize
blade breakage.
TRIGGER SWITCH
feature to prevent unintentional operation.
Releasing the trigger turns the motor OFF.
NOTE: This tool has no provision to lock
the switch in the ON position, and should
never be locked in the ON position by any
other means.
BLADE CLAMP RELEASE LEVER
WARNING: Cut hazard. Turn off
and remove battery from tool before
making any adjustments or removing or
installing attachments or accessories.
WARNING: Cut hazard. Blade
breakage may occur if the blade does not
extend past the shoe and the workpiece
during the cut. Increased risk of personal
injury, as well as damage to the shoe and
workpiece may result.
TO INSTALL BLADE INTO SAW:
full open position as shown in figure F.
2. Insert blade shank from the front.
to make sure blade is clamped securely.
NOTE: BLADE CAN BE INSTALLED
UPSIDE-DOWN TO ASSIST IN FLUSH-
TO CUTTING.
TO REMOVE BLADE FROM SAW:
WARNING: Burn hazard. Do not
touch the the blade immediately after use.
Contact with the blade may result in
personal injury.
full open position.
2. Remove blade.
FLUSH CUTTING (FIGURE G)
saw motor housing and pivoting shoe
permit close cutting to floors, corners and
other difficult areas.
insert the blade shaft into the blade clamp
with the teeth of the blade facing up.
close to the work surface as possible.
WOOD CUTTING (FIGURE H)
the work piece is firmly anchored or
clamped to prevent slipping.
to be cut.
pressure.
while cutting. Whenever possible, the
shoe must be held firmly against the
material being cut. This will prevent
the saw from jumping or vibrating and
minimize blade breakage.
METAL CUTTING (FIGURE I)
to clamp wood to the underside of the
sheet. This will ensure a clean cut without
excess vibration or tearing of metal.
reduces blade life and causes costly
blade breakage.
NOTE: You should spread a thin
film of oil or other coolant along the
line ahead of the saw cut for easier
operation and longer blade life.
For cutting aluminum, kerosene is
preferred.
POCKET CUTTING - WOOD ONLY
(FIGURE J)
Measure the surface area to be cut and
mark clearly with a pencil, chalk or scriber.
blade clamp securely.
Tip the saw backward until the bottom edge
of the shoe is resting on the work surface.
attain maximum speed.
deliberate upward swing with the handle
of the saw.
Always be sure blade is completely
through material before continuing with
pocket cut.
NOTE: IN AREAS WHERE BLADE